This design is a simple enclosure for my breadboard projects, so I can carry them around and not worry about anything breaking or moving around. It is half as tall as the Tall version, and considerably wider to accommodate the storage space and divider, which the Tall version lacks.

I’m using a 9v to 5v/3.3v board off of amazon, and have turned off the 3.3v rail to lessen wire clutter.

Pictured is a simple circuit with two LEDs in parallel. I hope to learn how to use microprocessors to accomplish greater tasks, but this is where I will start things 🙂

Things to improve on: The infill must be more than 5 percent to support the pegs, otherwise they can get pressed in too far during assembly.