Although previous breadboard holders considered things like wires, and provided channels for them, this design has been significantly modified to increase useability.

It features channels and holes to route wires through, in addition to removing a fair amount of the material to accommodate for as many pieces of hardware as I could.

• The previous version could hold:
  • A Breadboard

• The current version can hold:
  • Electronics (Intended for StemmaQT / Qwiik / GPIO devices)
  • Adapters (To fit additional hardware)
  • A breadboard

This design was created for a StemmaQT PiHat I will use for display, as well as a smaller device in the bottom. Things like Adafruit’s temperatures sensors, and similarly sized PCBs will fit.